FW update: Access Point HmIP-HAP v3.0.18

C H A N G E L O G
-----------------

Please note: Only use the firmware file in connection with the current software-version of the CCUx!

Device: HmIP-HAP - Access Point
alte Bezeichnung: YOU-HAP-TTU

Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany

Version 3.0.18 - 2023-09-29
--------------------------------------------------------------

** Bugfix
* LEDs flash blue and after some time the communication to the cloud is disrupted.
* The update is interrupted after the web bootloader is downloaded.

Version 3.0.16 - 2023-06-14
--------------------------------------------------------------

** Bugfix
* Multicast routing problems
* LED sequence wrong after get data from lookup server

Version 3.0.12 - 2023-05-31
--------------------------------------------------------------

** Bugfix
* Problems at Update

Version 3.0.10 - 2023-04-21
--------------------------------------------------------------

** Bugfix
* Times between lookup requests become too large
* After reboot (power) sometimes both APs connected to cloud
* No lookup request after get a crrfd url that is too long
* Time at close connection with 0xffff wrong

Version 3.0.4 - 2023-03-22
--------------------------------------------------------------

** Bugfix
* Encrypted frames not send to cloud
* The access point gets stuck in an endless loop when an update is triggered by Netfinder, but no different version is available on the update server.
* Backbone frames payload length wrong

** New Feature
* New parameters for multicast filter
* Connection to the Cludserver, LockupServer and Updateserver via IPv6 possible
* Use return code when closing the WebSocket to the AP for indication if the route is still valid.

** Improvement
* send destination unreach with LHL = 7-x

Version 2.4.28 - 2022-09-16
--------------------------------------------------------------

** Bugfix
* The access point sends frames to the server that are too long.
* Replies to frames from the server are lost.

** Improvement
* Set different timeouts for backbone Routers and backbone devices

Version 2.4.24 - 2022-05-12
--------------------------------------------------------------

** Bugfix
* The HAP treis to send a frame to all wired devices via any router

Version 2.4.20 - 2022-04-06
--------------------------------------------------------------

** Bugfix
* The HAP will reboot if it does not receive a response to an Inclusion Accept.

Version 2.4.18 - 2022-03-29
--------------------------------------------------------------

** Bugfix
* The HAP sends a route management frame with its own address marked as unreachable.

Version 2.4.16 - 2022-01-26
--------------------------------------------------------------

** Bugfix
* The access points (HAP/DRAP) always send the Manufacturer Code 0x01 (EQ3) in the Inclusion Request, even with OEM variants.
* Device becomes continuous BURST transmitter in case of cloud failure
* HAP answers status frames (ARR) with burst frames.

** New Feature
* Forward backbone route management frames to the cloud server

Version 2.4.12 - 2021-07-27
--------------------------------------------------------------

** Bugfix
* The HAP tries to start a sequence number validation on all frames and takes the destination address of the receiving frame as the source address.

Version 2.4.10 - 2021-07-15
--------------------------------------------------------------

** Bugfix
* FactoryReset first button press duration too long

Version 2.4.8 - 2021-06-29
--------------------------------------------------------------

** Bugfix
* KeyVisual key press data for long button press wrong

** Improvement
* Stronger evaluation of the RSSI value during routing

Version 2.4.4 - 2021-04-28
--------------------------------------------------------------

** Bugfix
* HTTP client hangs, if the previous connection was not closed.
* The access point interrupts the connection to the cloud server if the lookup server has delivered an incorrect URL.
* Incorrect KeyVisual signal when the AP disconnects from the cloud server.
* Wrong priority for frames to event listener
* The AccessPoint sends a response to an empty RM V1 request.
* HAP glows permanently turquoise in a Singel HAP installation
* Factory reset is also possible during operation.
* Fehler bei nicht erreichbarer UpdateURL
* Invalid Tcp/IP packet in the web bootloader.
* Websocket connection delay is only applied after restart.
* HAP do not respond to IGMPv3 Membership Queries

** New Feature
* Request routing information over HAP protocol
* Live OTAU Service

** Improvement
* Improve system behavior when HmIP-HAP has no internet connection.

Version 2.2.24 - 2020-12-16
--------------------------------------------------------------

** Bugfix
* Frames can no longer be sent. The stack remains in the busy state.

Version 2.2.18 - 2020-10-07
--------------------------------------------------------------

** Bugfix
* OTAU: "Update Data" frames are send with burst.

Version 2.2.16 - 2020-09-23
--------------------------------------------------------------

** Bugfix
* Web-Bootloader cancels download of CoProzessor update.
* Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.2.12 - 2020-08-26
--------------------------------------------------------------

** Bugfix
* Multicast Readressing is also applied to INTERFACE_LOCAL/CLOUD

Version 2.2.10 - 2020-08-24
--------------------------------------------------------------

** Bugfix
* If the application is defective, an incorrect application version is reported to the update server.

** Improvement
* No longer route cyclic multicast frames.
* Flashing behaviour when the centre is not accessible (flashing turquoise)

Version 2.2.4 - 2020-08-07
--------------------------------------------------------------

** Bugfix
* The device-specific configuration can no longer be retrieved with Netfinder.

Version 2.2.0 - 2020-07-16
--------------------------------------------------------------

** Bugfix
* With the custom lookup address, the path is not processed correctly.

** New Feature
* Advanced Routing

** Improvement
* Change the default update URL
* Improve the connection to the cloud server.

Version 2.2.2 - 2020-07-24
--------------------------------------------------------------

** Bugfix
* Wrong app sequence counter in status response frame.

** Improvement
* Do not accept frames to AnyRouter if it is known that it is not routed.

Version 2.0.40 - 2020-10-05
--------------------------------------------------------------

** Bugfix
* Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.0.36 - 2019-10-16
--------------------------------------------------------------

** Bugfix
* The HAP crashes and restarts when DHCP is switched off.

Version 2.0.34 - 2019-10-11
--------------------------------------------------------------

** Bugfix
* If the ICMP ping fails, but the lookup server query succeeds, the KeyVisual color is not updated.
* The local bootloader returns a wrong value during the update.

Version 2.0.32 - 2019-10-08
--------------------------------------------------------------

** Bugfix
* No connection to the server is established and the KeyVisual lights up yellow permanently.

** Improvement
* To test the Internet connection, an attempt is made to send a ping to the lookup server; if the ping fails, an attempt is made to establish a connection anyway.

Version 2.0.26 - 2019-07-23
--------------------------------------------------------------

** Bugfix
* With the custom lookup address, the path is not processed correctly.
* HAP firmware stops after a FactoryReset is cancelled.
* FactoryReset has no timeout.

Version 1.2.26 - 2020-10-06
--------------------------------------------------------------

** Bugfix
* Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 1.2.12 - 2018-04-19
--------------------------------------------------------------

** Bugfix
* the configuration data will sometimes be corrupted during the update, causing a factory reset
* Look up server is requested just one time after startup

--- END OF FILE ---