De firmware van de Homematic IP CV-ketel en warmtebron module is geüpdatete naar versie 2.0.10. Deze update bevat een bugfix voor een probleem waarbij het niet mogelijk was om statusinfo te verkrijgen van een virtueel kanaal, en waarbij de sortering van de tekst in de statusinfo incorrect was. De changelog bevat alle informatie van de huidige en eerdere firmware updates. De update wordt spoedig beschikbaar via de Homematic IP app, voor gebruikers van het Homematic IP Access Point. Voor gebruikers van de CCU3 wordt de update zichtbaar via de Homepage van de WebUI.
C H A N G E L O G
-----------------
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-WHS2 - Homematic IP Switch Actuator for heating systems – 2 channels
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 2.0.010 - 2022-05-23
--------------------------------------------------------------
** Bugfix
* Status info cannot request from virtuel channels
* Sorting of status info container wrong
Version 2.0.008 - 2022-05-10
--------------------------------------------------------------
** Improvement
* Code optimization
Version 2.0.006 - 2022-04-27
--------------------------------------------------------------
** Bugfix
* Due to the default settings of the link parameters, a conditional switch command is not handled according to specification
Version 2.0.004 - 2022-03-31
--------------------------------------------------------------
** Bugfix
* Weekprogram-Status(-with Ack) is not triggered in case of Mode-Change
* MIOB "Normally Closed"-Input: Cooling is not activated
Version 2.0.000 - 2022-02-07
--------------------------------------------------------------
** Bugfix
* Direct link CO input to FALx deactivates internal channel A
* If the switch-on and switch-off times in the Easy Profile are set to "Not active" at the same time, the device hangs up.
* WHS2 fails sporadically and can only be operated again after the 230 volt supply has been interrupted
** New Feature
* Use of the HmIP-WHS2 in connection with the HmIP-BWTH wall thermostat
** Improvement
* The time information telegram does not contain a note about the sommer / winter time change.
* If possible, send multicasts only to PARTNER_ALL_WIRED_DEVICES instead of to PARTNER_ALL_DEVICES.
Version HmIP-WHS2 V1.4.002 - 2021-11-08
--------------------------------------------------------------
** Bugfix
* CSC werden mit NAK beantwortet.
* NAK auf DEC Execution_Code: Set_weekprogram_target_channel_lock
Version HmIP-WHS2 V1.4.000 - 2018-11-23
--------------------------------------------------------------
** Bugfix
* Homematic IP actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover.
** New Feature
* Firmware-Erweiterung erforderlich damit Gerät mit HmIP-FALMOT-C12 gepaired werden kann
* AppSequenceCounter-Überwachung auf Bereich ausweiten
** Improvement
* All PowerUp parameters, that are listed in list 3 of the device, must be supported
--- END OF FILE ---