FW update: CV-ketel en warmtebron module HmIP-WHS2 v2.2.0

05-09-2024

De firmware van de Homematic IP CV-ketel en warmtebron module is geüpdatete naar versie 2.2.0. Deze update bevat een bugfix voor een probleem waarbij de event counter verkeerd telde als er meerdere koppelingen tussen sensoren en actoren bestonden. De changelog bevat alle informatie van de huidige en eerdere firmware updates. De update wordt spoedig beschikbaar via de Homematic IP app, voor gebruikers van het Homematic IP Access Point en de Homematic IP Home Control Unit. Voor gebruikers van de CCU3 wordt de update zichtbaar via de Homepage van de WebUI.

C H A N G E L O G
-----------------

Please note: Only use the firmware file in connection with the current software-version of the CCUx!

Device: HmIP-WHS2 - Homematic IP Switch Actuator for heating systems – 2 channels

Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany

Version 2.2.000 - 2023-11-09
--------------------------------------------------------------

** Bugfix
* Wrong evaluation of the event counter with multiple links between sensor and actuator
* For heat demand control on the VirtB channels, a level command should also be taken into account in addition to a conditional switch command.

Version 2.0.010 - 2022-05-23
--------------------------------------------------------------

** Bugfix
* Status info cannot request from virtuel channels
* Sorting of status info container wrong

Version 2.0.004 - 2022-03-31
--------------------------------------------------------------

** Bugfix
* Weekprogram-Status(-with Ack) is not triggered in case of Mode-Change

Version 2.0.000 - 2022-02-07
--------------------------------------------------------------

** Bugfix
* WHS2 sends many status messages during inclusion process
* If the switch-on and switch-off times in the Easy Profile are set to "Not active" at the same time, the device hangs up.
* WHS2 fails sporadically and can only be operated again after the 230 volt supply has been interrupted

** Improvement
* The time information telegram does not contain a note about the summer / winter time change.
* If possible, send multicasts only to PARTNER_ALL_WIRED_DEVICES instead of to PARTNER_ALL_DEVICES.

Version 1.8.000 - 2018-12-19
--------------------------------------------------------------

** Bugfix
* Weekprogram under certain circumstances does switch all actuator channels if switched all at the same time

** Improvement
* Weekprogram implemented
* All PowerUp parameters, that are listed in list 3 of the device, must be supported.
* Disable MSG to AC parameter implemented
* Application Sequence Counter handling adapted
* Configuration parameter for pushbutton channel (long presstime, double presstime, repeated long press timeout) added

** Modification
* Change to Version 1.8.000.

Version 1.6.000 - 2017-01-30
--------------------------------------------------------------

** Bugfix
* Error in heat demand function (VIRT B-Channels of both actuators) fixed.

** Modification
* Change to Version 1.6.000.

Version 1.4.000 - 2016-09-20
--------------------------------------------------------------

** Bugfix
* Issue with global pump protection function (in conjunction with the FAL) fixed.

** Modification
* Change to Version 1.4.000.

Version 1.2.000 - 2016-09-08
--------------------------------------------------------------

--- END OF FILE ---

glqxz9283 sfy39587stf02 mnesdcuix8
sfy39587stf03
sfy39587stp14