FW update: Wired Access Point HmIPW-DRAP v3.0.20

C H A N G E L O G
-----------------

Please note: Only use the firmware file in connection with the current software-version of the CCUx!

Device: HmIPW-DRAP - Homematic IP Wired Access Point

Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany

Version 3.0.20 - 2023-12-08
--------------------------------------------------------------

** Bugfix
* Bus power somtimes switch off at update

Version 3.0.18 - 2023-09-29
--------------------------------------------------------------

** Bugfix
* LEDs flash blue and after some time the communication to the cloud is disrupted.
* The bus supply voltage is switched on and off several times during booting.

Version 3.0.16 - 2023-06-14
--------------------------------------------------------------

** Bugfix
* Multicast routing problems
* LED sequence wrong after get data from lookup server

Version 3.0.12 - 2023-05-31
--------------------------------------------------------------

** Bugfix
* Problems at Update

Version 3.0.10 - 2023-04-21
--------------------------------------------------------------

** Bugfix
* After reboot (power) sometimes both APs connected to cloud
* No lookup request after get a crrfd url that is too long
* Time at close connection with 0xffff wrong

Version 3.0.4 - 2023-03-22
--------------------------------------------------------------

** Bugfix
* Encrypted frames not send to cloud
* The coprocessor crashes if a load is connected to the bus during operation.
* Backbone frames payload length wrong

** New Feature
* Use return code when closing the WebSocket to the AP for indication if the route is still valid.

** Improvement
* send destination unreach with LHL = 7-x

Version 2.4.28 - 2022-09-16
--------------------------------------------------------------

** Bugfix
* Replies to frames from the server are lost.
* The access point sends frames to the server that are too long.

** Improvement
* Set different timeouts for backbone Routers and backbone devices

Version 2.4.22 - 2022-05-09
--------------------------------------------------------------

** Bugfix
* BUS is not switched on after Power UP

Version 2.4.20 - 2022-04-07
--------------------------------------------------------------

** Bugfix
* The DRAP will reboot if it does not receive a response to an Inclusion Accept.

Version 2.4.18 - 2022-03-29
--------------------------------------------------------------

** Bugfix
* The DRAP sends a route management frame with its own address marked as Unreachable.
* The display switches off and communication with the bus is disturbed.

Version 2.4.16 - 2022-01-26
--------------------------------------------------------------

** Bugfix
* The access points (HAP/DRAP) always send the Manufacturer Code 0x01 (EQ3) in the Inclusion Request, even with OEM variants.

** New Feature
* Forward backbone route management frames to the cloud server

Version 2.4.14 - 2021-08-16
--------------------------------------------------------------

** Bugfix
* Error flag Bus overload in StatusInfo is not reset
* Carrier sense always 0
* The DRAP tries to start a sequence number validation on all frames and takes the destination address of the receiving frame as the source address.
* HTTP client hangs if the previous connection was not closed.
* The access point interrupts the connection to the cloud server if the lookup server has delivered an incorrect URL.
* Sends to MulticastAllWiredDevices over Backbone with wrong CRRFD Address
* Error with updateURL not accessible.
* Websocket connection delay is only applied after restart.
* DRAP after firmwareupdate over CCU3 not reachable
* Full support for DEC Identify.
* DRAP power supply rated current exceeded: DRAP display goes off, nothing else happens.
* DRAP do not respond to IGMPv3 Membership Queries

** New Feature
* Request Route to device for Live OTAU support

** Improvement
* The web bootloader should prohibit a downgrade to a smaller major version.
* If a DRAP is operated with 2 separate strings, multicast frames are sent to bus 1 and bus 2 one after the other - this could also happen simultaneously.

Version 2.2.24 - 2020-12-16
--------------------------------------------------------------

** Bugfix
* Frames can no longer be sent. The stack remains in the busy state.

Version 2.2.16 - 2020-09-23
--------------------------------------------------------------

** Bugfix
* Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.2.12 - 2020-08-26
--------------------------------------------------------------

** Bugfix
* Multicast Readressing is also applied to INTERFACE_LOCAL/CLOUD

Version 2.2.10 - 2020-08-24
--------------------------------------------------------------

** Bugfix
* If the application is defective, an incorrect application version is reported to the update server.

Version 2.2.4 - 2020-08-07
--------------------------------------------------------------

** Bugfix
* The device-specific configuration can no longer be retrieved with Netfinder.

Version 2.2.2 - 2020-07-24
--------------------------------------------------------------

** Bugfix
* Wrong app sequence counter in status response frame.
* In loop mode, inclusion request frames are discarded in the coprocessor.

** Improvement
* Do not accept frames to AnyRouter if it is known that it is not routed.

Version 2.2.0 - 2020-07-16
--------------------------------------------------------------

** Bugfix
* With the custom lookup address, the path is not processed correctly.

** New Feature
* Advanced Routing

** Improvement
* change default update URL
* Block duplicate multicast frames when routing.
* Accept CCU SGTIN within Update Server URL
* Changing from switching to routing between the two buses of the DRAP

Version 2.0.28 - 2020-02-24
--------------------------------------------------------------

** Bugfix
* With the custom lookup address, the path is not processed correctly.

Version 2.0.26 - 2020-10-13
--------------------------------------------------------------

** Bugfix
* Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.0.22 - 2019-06-17
--------------------------------------------------------------

** Bugfix
* No communication between RF and wired components

Version 2.0.18 - 2019-04-08
--------------------------------------------------------------

** Bugfix
* DRAP lights up orange after update.

Version 2.0.16 - 2019-02-05
--------------------------------------------------------------

** Bugfix
* LED sequence for factory reset is to slow
* Wrong DHCP Vendor ID. DRAP reports as HAP

** New Feature
* OTAU multicast frames have to be routed

Version 2.0.12 - 2018-10-19
--------------------------------------------------------------

** Bugfix
* If the DRAP is configured as a router and it sends a validation request before it gets an IP address from the DHCP server, the DRAP restarts.
* sometimes the watchdog is triggered while Bus is powering up

Version 2.0.6 - 2018-08-27
--------------------------------------------------------------

** Improvement
* Only evaluate the HTTP response code, not the response phrase.

--- END OF FILE ---